INSTALLATION CELL: -
The Poolstore "Q" DIAMOND cell housing will directly accept 50mm pipe.
If 40mm pipe is being used, glue in reducers supplied with the chlorinator to both the inlet and outlet ports of the cell housing.

Install cell housing in return line to pool as the last item of equipment closest to the pool. Where large capacity heaters (i.e. 24kW - 200Mj or greater) are used, it will be necessary to install the cell in a heater by-pass line. The elevated temperatures of the heated water can effect the performance of the cell and in some instances the cell and housing. Warranty claims will not be accepted where this precaution is not taken.

INSTALLATION: -
Firmly affix the power pack in a protected location to a rigid surface approximately 1 to 1.5m above floor or ground level. DO NOT connect the POOLSTORE "Q" DIAMOND chlorinator via an extension lead.
Plug the POOLSTORE "Q" DIAMOND power lead into the supply socket outlet, which is turned "OFF" and make sure that the CELL switch is in the OFF position and that the TIMER OVERRIDE SWITCH is "ON".

Plug the filter pump supply plug into the bottom of the POOLSTORE "Q" DIAMOND
power pack. DO NOT plug a double adaptor into the pump outlet as by doing so you will negate an inbuilt safety feature. Set the time-clock by pushing the pins in towards the centre for the time or times that you wish the pump and chlorinator to operate. Set the existing time against the white arrow on the time-clock.
Now make sure that all valves, if any, in the pools recirculation system are in the "OPEN" position and that the filter pump is primed with water and then turn on the power pack at the supply socket.

Note that the pump is now running, but that the chlorinator is OFF. The CELL SWITCH should NOT be turned ON until all the salt in the pool has dissolved. This will take from 48 hours to 72 hours depending on the pool water temperature and the amount of circulation. During this time the filter will run continuously. Automatic operation of the pump is achieved by switching the pump switch to auto. To hasten the dissolving of the pool salt, we recommend brushing the pool floor occasionally to get water circulating around the salt (much like stirring sugar in tea or coffee). When all the salt has dissolved, and not before, turn the chlorinator on by the CELL switch. You will now notice a cloud of small bubbles being discharged from the cell plates - and the chlorinator monitor lights will glow.

The number of lights will depend on: -
1. Position of the chlorine adjustment knob
2. Water Salinity
3. Temperature